• Filter

Dual-wavelength testing Tests multimode and singlemode fiber Measures optical power and loss at 850 nm and 1300 nm using the 850/1300 source and meter Measures optical power and loss at 1310 nm and 1550 nm using the 1310/1550 source; calibrated wavelengths in the power meter at 1490 nm and 1625 nm also allow for readings from other sources Offers quick remote identification of cabling runs with FindFiber Remote IDs Conduct pre-testing and qualify cabling runs Auto-senses source wavelength Saves 1000 test results Single port testing for simple network connection Ruggedly built for demanding field use LinkWare Cable Test Management Software documents, reports, and manages all test data

Extreme Sensitivity to Small Gold Nuggets High Precision Dual-Control Ground Balance Iron Disc Mode for Iron & Hot Rock Rejection Deep Target Audio Boost Lightweight & Hip-Mountable Available with Either a 6 ½” or 10” Elliptical Search Coil Operating Frequency: 71 kHz Our detector is ORIGINAL from USA. Many other online sellers are selling pirated one. Beware!

24 V Loop power supply HART mode setting with loop power (adds 250 ohm resistor) 100 % larger dual display 1,200 ohm drive capability on mA source Enhanced backlight with two brightness settings 0-100 % mA Span Check buttons to toggle between 4 and 20 mA Infrared I/O serial port compatible with FlukeView® Forms Software Version 2.1 (available Feb. 2003) Externally accessible fuses for easy replacement DMM designed to meet 1000 volt IEC 1010 CAT III standards Precision 1000 V, 440 mA true-rms digital multimeter Frequency measurement to 20 kHz Min/Max/Average/Hold/Relative modes Diode Test and Continuity Beeper Simultaneous mA and % of scale readout 20 mA dc current source / loop calibrator / simulator Manual Step (100 %, 25 %, Coarse, Fine) plus Auto Step and Auto Ramp Externally accessible battery for easy battery changes Fluke combined a loop calibrator and a DMM to give process technicians double the power in one tool (the Fluke 787). Now we made it even better – the ultimate loop calibration multimeter – the Fluke 789 ProcessMeter. The 789 has a display that's not only twice as large, but also twice as bright with two levels of backlighting. With its...

Category: Oil Analyser

Portable diesel fuel and oil contamination monitor.Fitted with laser particle counter. Results inISO4406, NAS and SAE formats.High viscosity pumpallowing oils up to 424cst.

Category: Oil Analyser

Portable diesel fuel and oil contamination monitor.Fitted with laser particle counter. Results inISO4406, NAS and SAE formats.High viscosity pumpallowing oils up to 424cst. Water Monitor and displayfor % Saturation

Category: Oil Analyser

Portable diesel fuel and oil contamination monitor.Fitted with laser particle counter. Results inISO4406, NAS and SAE formats.High viscosity pumpallowing oils up to 424cst. Filtertechnik water in dieseland oils sensor. 4-20mA output scaled over 0-500ppm.

Category: Oil Analyser

Portable PPM measurement unit for use on diesel fuelsand oils. Gives water content levels of real time PPM.Built in rechargeable battery and pump.

Category: Oil Analyser

• Live readouts of: NAS 1638, SAE A5 4059 & ISO 4406 - live on screen • 4 Particle sizes: 4µ, 6µ, 14µ & 21µm • Windows 7 compliant • Highly accurate+/- 0.5 ISO code • Alarm indication and relay outputs • Real time analysis of fluid cleanliness • Fluid compatibility: Hydraulic & Lubrication oils, mineral & synthetic, diesel fuel, biodiesel & petrol